1. Home
  2. Living

DIY Floral Wedding Photo Frame Display

Looking for a creative and fun way to display your favorite photos? Well, this wedding photo frame project will teach you how to do just that! This hoop photo display is fun to take on your typical picture frame; it allows you to show off your photos in a dainty wooden hoop, covered with floral leaves. Since this picture display can hold two photos, I also found that this project makes a great centerpiece or even a table number display for weddings. Overall its an easy and cheap project to whip up, and of course you can always add more things to make it your own!

Wedding Photo Frame Display

Materials diy floral photo display

Materials to craft this wedding photo frame:

  • 8″ Wood embroidery hoop
  • String
  • Tape
  • Scissors
  • Glue gun
  • Artificial plant leaves
  • 5″ x 3.5″ Oval pine plaque
  • 2 Pictures (same size)

Directions step by step to create a photo frame or a wedding table number display:

Diy floral photo display step1

Step 1: prepare the faux plant

You will just be using the inner piece of your embroidery hoop. Take the artificial plant and separate the stems, then trim the ends of the stems.

Diy floral photo display step2

Step 2: add glue on the plant

Take your glue gun and start gluing on the plant pieces. Make sure to hold down the stems for a couple seconds to ensure that stays as the glue dries. Also be very careful to not burn your fingers!

Diy floral photo display step3

Step 4: ensure both sides

Decide how you want to place the plant pieces– you don’t have to necessarily cover the entire hoop. To ensure that both sides of the hoop are lush and full, add some pieces on the edges and inside of the hoop; it makes it look more esthetically pleasing to the eye.

Diy floral photo display step4

Step 5: add the bottom glue

Once you have finished gluing all the plant pieces to the hoop, take bottom of the hoop and glue it onto the oval wood plaque. Make sure to hold it down for about 30 seconds to keep the hoop in place as the glue dries.

Diy floral photo display step6

Step 6: photo string

You almost are done! Now take your two photos and glue or tape the back of the photos together and place a strand of string right in the middle of the two pictures.

Diy floral photo display step7

Step 7: Hang from the middle

Find the middle of the hoop, take your picture and figure out how far down you want the photos to hang. Once you have decided, glue the string in the inside of the hoop.

Conclusion

And there you have it! Hope you guys enjoyed this DIY project, and I hope you guys have fun displaying all your favorite photos.

Stay crafty and creative!

Leave a Reply

Your email address will not be published. Required fields are marked *